Hytera New Firmware Upgrade Available

There is a new version of the Hytera Upgrade available. This takes you to V6.05.07.006 firmware version. This upgrade offers at first sight no new functionality. Also, you can not with this firmware code plug of a GPS radio with a GPS radio without writing. This is an advantage in itself because it has been found in the past that radios without GPS went anyway transmit data. But we bring all Hytera radios through this upgrade at the same level so that different plugs new longer required. The code plugs for radios with firmware they are available on this site. The upgrade should take place according to the enclosed instructions. The upgrade has been tested on a MD785 (see below). As always, we want to emphasize that upgrading the use or manipulation of code plugs is at your own risk.
The Upgrade Kit can be found here .

http://translate.google.ca/translate?hl=en&sl=nl&u=http://ham-dmr.nl/%3Fp%3D1774&prev=search



Hytera PD-365 in download mode
 To put the Hytera PD-365 in download mode follow the info
1. Preparation:
- Download the new CPS software for the 3 Series
- Download the upgrade kit for the 3-series
- Remove the old CPS for the 3-series complete.
- Install the new CPS
2. Upgrade
Step 1 Power off the subscriber, and take down the battery
Step 2 Connect to the subscriber PC.
Step 3 Hold SK1 then put in the battery, wait for 3 ~ 5 seconds, then release SK1, so as to enter the download mode.
Step 4 Run the software, select the right COM, if do not find the right COM, click "Refresh" button to refresh ..
Step 5 Click "Upgrade" in the main interface to start, the information up the progress bar will turn to "Updating, please wait ...".
Step 6 The progress bar will display rate after about 5 seconds later, and about 1 minute later will prompt "Update completed successfully" after finished:
Step 7 Wait for subscriber restart.
Step 8 Click "OK" and power off the subscriber.